Wednesday, April 30, 2014

Lie-Nielsen in Frederick, MD

I am heading back down to Maryland tomorrow afternoon for the Lie-Nielsen Handtool Event on Friday and Saturday at Exotic Lumber in Frederick, MD. 



The last time I went to a this show I ended up waiting 6 hours for my car to be fixed after losing much of its function on the George Washington Bridge. (Yes, the weekend was still worth it.)

Lie-Nielsen will have several benches set up with most of their tools sharpened and ready to be put to work. I will have a bench there too, as will a few other demonstrators. 

As with every event I've been to, I will be spending most of my time running people through the process of making moulding by hand. The rest of the time I will be resisting the purchase of a 10 1/4. 

The show is from 10-6 on Friday and 10-5 on Saturday.

If you get stuck on the turnpike send me an email and I'll tell you which roads are not worth walking a mile down to waste time. The best bet is to just call Raney Nelson, he'll talk you off the ledge (and, likely, onto another one).

Monday, April 28, 2014

Matching Specific Moulding

At this stage we all know that hollows and round are, despite their simple curves, extraordinarily complex. With a single pair you are able to make scores of mouldings. With a series of pairs you are able, and encouraged, to create something grand.

I am often presented with the same concept: "I want to make a small amount of moulding to match something specific."

Hollows and rounds allow you to make this same moulding. In fact, they encourage you to make this small amount of moulding. These tools embolden you to make a specific profile that cannot be bought, produced with routers or shapers, and are difficult to carve or scrape along a great length.

......

I was recently sent an example of a moulding. My best guess at the traced moulding is as follows.


I don't know if this is accurate because I was looking at a literal tracing of a very specific profile. But this is how I'd make the above:

Rabbet plane:


Again, rabbet plane. I would include these rabbets in the process above. I just want to acknowledge the rabbets that  separate the various curves to those that guide that rounds.



Rabbet plane to create chamfers to guide the hollows:



#7 Round:



#14 Round:



#12 Round



#8 Hollow


#18 Hollow 



To the original point: If you tell me that you want to create a very specific profile, I will likely send you an envelope of plane cutoffs. Find out which planes most accurately match the curves. 




The closest fit is likely ideal, but we can get closer still. I just need your help.

And if you tell me that the person who hung my crown moulding did it upside down, you're in the majority. Tell me that they weren't able to cope, I agree. Tell me that it's worth my time to change, I'll tell you that I wouldn't have written this blog otherwise.

That's nice quartersawn beech, right? it wasn't always like that, but stay tuned...